LAB ONE? Introduction - UCIIn this first part of the lab, you will learn how to install and tune GNS3. You will
also learn how to ... Exercise 1(B). Settings. 1. Open GNS3 and go to Edit ->
Preferences on Windows or GNS3 -> Preferences on Mac ... Then click on New,
then on Browse to select the Cisco IOS image on your computer. Change the
Chassis to ...Lab 4reflect the new topology. 1. Issue a ping command from PC4 to PC1. Do not
terminate the ping command until this exercise is completed in Step 4. 2. To
disconnect the Ethernet cable (remove a link) connected to interface
FastEthernet0/0 on Router4 in GNS3, you need to shutdown the interface.
Removing the link itself will ...LAB THREE ? STATIC ROUTINGin GNS3, and then open the console window so that the configuration commands
can be entered. Once in the ... Lab 3 ? Page 3. NOTE. The Cisco routers in GNS3
sometimes start up in Privileged instead of the User ..... Build a new static routing
entry on Router1 for network 10.0.3.0/24 to Router2. (FastEthernet0/1). 6.Skills Assessment ? Student Training (Answer Key)Page 1 of 55. CCNA: Connecting Networks. Skills Assessment ... used to verify
that the student initialized the devices correctly in Part 1, Step 1. ... Refer to the
Router Interface Summary Table at the end of the lab for the correct interface
identifiers. ..... ppp authentication chap). Create a local database entry to use for
CHAP.Lab ? Configuring EtherChannel - CCNAv6.comBackground / Scenario. Link aggregation allows the creation of logical links that
are comprised of two or more physical links. This provides increased throughput
beyond using only one physical link. Link aggregation also provides redundancy
if one of the links fails. In this lab, you will configure EtherChannel, a form of link ...
